Etiqueta: Equipment

The Design

First, better vospopolzovatsya temporary shelter, to allow time to study the earth's surface, ensure the correct place to build a garden at home. When they know the properties of soil on the site of the future construction and topography of the site, you can begin to determine the size of the foundation. As a general rule, building restriction depends on the mechanical properties of the soil, and often when determining the size of the foundation should be considered not the ground on which relies directly on the building, and a layer, which lies deeper, because in many cases, subsidence was caused by a slow contraction of deep-lying layer of clay. Often there is in place utilities and, perhaps, just where you are going to place their buildings. This is especially true fulfillment of the requirement for placement of individual building mainly on the free areas, including areas previously considered unsuitable for construction or for agriculture. These reasons make it necessary to specify the size of plots allocated to an individual house, garden or orchard, because when you turn in the construction of artificial above-ground or underground, "territories" the results taking into account land area in comparison with the data recommended in the SNP will be different. Norms GSP 43-85 "Building the territory of collective gardens and buildings "with changes and additions approved in 1988 are presented in accordance with new legislative instruments. These standards apply to the design of buildings the territory of collective gardens, garden houses and other buildings of public and private use members of gardening partnerships.

Designing Autonomous Sources

In recent times there are discussions devoted to the selection of the optimal heating systems of various scales, from the heating system circuit flat to the heating system of the city. There are two Classical choices: centralized or autonomous heating. Each of these options has both advantages and disadvantages of which were published many times articles in various publications, including journal "New Subject". As a result, attempts to optimize the classical scheme of "born" combined schemes: quarterly boilers, home heating with individual door-to-door with domestic boilers, etc. To date, one of the the most popular solutions is considered to be the following: a source of heat (whether CHP, quarterly or rooftop boiler room), two-pipe heating system of pre-insulated pipes and teplopunkt (group home, any individual, so-called ITP, consumers). More detailed features of ITP are described in the article, Mr. Shemchuk VV, which was published in the previous issue, so in this article on this We do not dwell. However, it should be noted that the use of ITP in our opinion is more rational in terms of new construction (the ability to provide a heat input to the apartment and the door-to-door beam layout of the heating system) than in the reconstruction of existing systems (heating risers are in every room of the apartment, and, as a rule, the heating system – One-pipe). All this leads to the fact that efforts to improve the heating of existing homes, the use of ITP would entail the reconstruction of not only heating but also overhaul the entire house.